News Centre

Send your inquiry

Failure Analysis of Engineering Plastic Parts: Cracking, Wear & Chemical Attack - cover image

Failure Analysis of Engineering Plastic Parts: Cracking, Wear & Chemical Attack

The Five Common Failure Modes

Mode

Appearance

Root Cause

Brittle cracking

Sharp, clean fracture, no deformation

Stress concentration, impact, low temperature

Environmental stress cracking

Fine crazing, then cracks near contact points

Chemical contact plus stress

Creep deformation

Permanent sagging or flow

Sustained load, elevated temperature

Wear

Material loss on sliding surfaces, debris

Insufficient PV rating or contamination

Chemical attack

Swelling, softening, discolouration

Incompatible medium or cleaning agent

Diagnostic Sequence

· Establish the failure pattern — is it a single part or the whole batch? Consistent failures point to design

· Examine the fracture surface — brittle fractures are flat and shiny, ductile failures show drawing

· Check for chemical exposure — cleaning agents, lubricants, and process fluids are frequent culprits

· Measure dimensions against the drawing — swelling and creep both leave dimensional fingerprints

· Review the thermal history — has the part run hotter than intended?

· Confirm the delivered material against the specification, including grade and filler content

k12 (5)

Environmental Stress Cracking: The Quiet Killer

ESC deserves special attention because it looks like a material defect and is almost always a design issue. A moulded or machined part carries internal stress; bring it into contact with a chemical that is nominally compatible and the two combine into cracking at stress levels far below the material’s strength. Common triggers include thread-forming screws in moulded bosses, press fits, and cleaning solvents. Annealing after machining removes much of the internal stress and is the single most effective preventive measure. Avoiding sharp internal corners and reducing assembly interference loads completes the fix.

Prevention Beats Substitution

The usual reaction to a failure is to specify a more expensive material. Sometimes that is correct — but far more often the failure would recur in the upgraded polymer because the underlying cause was geometric. A cracked boss will crack in PEEK as readily as in POM if the wall is too thin and the screw is over-torqued. Work through the failure mode systematically, confirm the mechanism with data, and change one variable at a time. NAGOMER‘s engineers support customers through this process with machined test parts, material data, and second opinions on drawings before the next production run starts.

Related reading: Creep & Stress Relaxation Design, Chemical Resistance Chart for PEEK, and Engineering Plastic Quality Control.

esd pom

FAQ

Q1: Why do plastic parts crack at screw bosses?

Usually a combination of insufficient boss wall thickness, over-torquing, and internal moulded or machining stress. Environmental stress cracking from lubricants or cleaning agents often finishes the job.

Q2: Can a material defect be distinguished from a design failure?

Often yes. A design failure usually repeats predictably across parts and locations; a material defect tends to appear randomly. Fracture surface examination adds further evidence.

Q3: Does annealing prevent cracking?

It removes residual stress and dramatically reduces the risk of environmental stress cracking, but it cannot compensate for an under-designed wall section or excessive assembly load.

Q4: How do I identify chemical attack?

Look for swelling, softening, discolouration, or a sticky surface. Weighing a failed part against an unused one often reveals moisture or solvent uptake.

Q5: Should I switch to a stronger material after a failure?

Only after understanding the cause. If the mechanism is geometric or environmental, a stronger polymer will usually fail the same way at higher cost.

Investigating a failed component? Contact NAGOMER for material data, machined test parts, and engineering support on root cause analysis.

────────────────────────────────────────

NAGOMER — Professional Engineering Plastics Solutions

www.nagomer.com  |  info@nagomer.com

滚动至顶部

Inquiry form